
SETUP & TIPS
During installation
On this page you will find everything you need to know during installation.
CABLES
Remember to use enough cable holders along the boundary cable - if it is loose you risk the robot cutting the cable

SETUP & TIPS
On this page you will find everything you need to know during installation.
Remember to use enough cable holders along the boundary cable - if it is loose you risk the robot cutting the cable
Use a few pegs to securely lay out the boundary cable (as this makes it easier to move it around afterwards).
Unscrew the blades from your robot before a test run.
Allow the robot to do a few test runs moving around the boundary cable laid out where it is needed. You can then peg the boundary cable into the ground all the way round.
Have you followed the steps above? Then check out our post-installation tips.